MIL-DTL-44117B
1. Kit contents:
a. Attachment strip - 1 each
b. Adhesive pack (with mixing stick) - 1 each
2. Install replacement attachment strip on helmet as follows:
a. Abrade the inner section of the helmet in the area where the previous attachment strip was
located using 80 grit aluminum oxide abrasive cloth (NSN 5350-00-192-5047) to the point of
leaving a rough surface.
b. Wash abraded area with a lint free cotton cloth wet with denatured ethyl alcohol.
c. Allow to air dry for 5-10 minutes.
d. Mix the adhesive pack components following directions on the packet.
e. Apply the mixed adhesive to the back (smooth) side of the attachment strip and to the
abraded area in the helmet.
f. Set attachment strip in place and allow to remain untouched for 15-20 minutes.
3.5.4.4 Replacement attachment tab kit. The replacement attachment tab kit shall consist of the
following:
Attachment Tab (Drawing 8-2-604)
- 1 each
Screw, Item 7 (Drawing 8-2-601)
- 1 each
Washer, Item 8 (Drawing 8-2-601)
- 1 each
A-Nut and Post (Drawing 8-2-647 and
8-2-610) - 1 each
Paper Instruction Label (see 3.5.4.4.1)
- 1 each
3.5.4.4.1 Paper identification and instruction label (tab kit). The paper and printing
requirements shall be as specified in 3.5.4.3.1.
(Identification label contents)
Item description
Stock number
Contract number
Contractor's name
Instructions for use of replacement attachment tab kit:
1. Kit contents:
a.
Attachment Tab - 1 each
b.
Screw - 1 each
c.
Washer - 1 each
d.
A-nut and Post - 1 each
2. Install replacement tab on helmet shell as follows:
8
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business