MIL-DTL-44117B
a. Install post through tab eyelet and place washer on post. Align tab eyelet and post with hole
in shell. Snap fastener socket on tab (must face in-ward).
b. Install washer on screw and apply thread sealing compound (NSN 8030-00-058-5398) to
screw threads. Insert screw through helmet shell and thread into post. Screw head shall be on
outside of helmet.
3.5.5 Instruction manual. An instruction manual shall be furnished by the contractor with each
helmet. The manual shall be placed into the crown of the helmet. The text printing, collation,
folding, and stitching of the manual shall be in accordance with the standard sample (see 6.4). The
cover shall be antique white book paper conforming to best commercial practices. The text paper
shall be white offset book paper conforming to best commercial practices.
3.5.6 Identification labels/markings.
3.5.6.1 Helmet shell. Each helmet shell shall have a permanent type identification
label/marking applied to the interior surface of the helmet shell in the location shown on Drawing
8-2-601. The label shall be white, approximately 1 by 2 inches in size, and the characters shall be
black, 3/32 inch high minimum. The label, after being applied to the helmet, shall be coated with
clear lacquer or resin. The label/marking shall have the following information:
Nomenclature
Size
Serial number
Lot number
3.5.6.2 Inner helmet. The inner helmet shall have an identification label/marking attached to
the nape strap in accordance with requirements specified on Drawing 8-2-613.
3.5.6.3 Special marking, helmet shell and inner helmet. In addition to the markings required
on the labels specified in 3.5.6.1 and 3.5.6.2 for the helmet shell and inner helmet, the
labels/markings shall include, using characters 3/32 inch high, the following information:
Manufactured under license agreement granted by the U.S. Government pursuant to Contract No.
XXXXXXX with (Manufacturer's name).
3.5.6.4 Bar code Label/Tag Each finished helmet or individual component (when purchased
separately) shall be individually Bar-Coded with a Type VIII, Class 17 label/tag conforming to
MIL-DTL-32075. The label/tag shall be located so that it is completely visible when packaged as
specified in section 5.1.
3.6 Construction. The construction shall conform in all respects to Drawings 8-2-57, 8-2-600
through 8-2-607, 8-2-610, 8-2-611 through 8-2-618, 8-2-644 (edging requirement only), 8-2-647,
8-2-658, 8-2-659, 8-2-661 (Pinwheel configuration only), and 8-2-830 and as specified herein.
3.6.1 Helmet shell. The helmet shell shall be a laminate structure composed of resin coated
reinforcing material compression molded by heat and pressure.
9
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business