MIL-DTL-44117B
TABLE VIII. End item visual examination - Continued
Examine
Defect
Classification
Major
Minor
Exterior finish
Not a smooth, uniform coating (i.e., run or sag
coating of shell
affecting an area more than one square inch) 1/
234
Continued
Foreign matter (such as dirt, stain, oil or grease)
embedded in or appearing on the finish
235
Color of finish not as specified
142
Any unauthorized repair
143
Shell edge
Any cut, tear, or hole
144
beading
Not fully positioned over edge of helmet shell
145
Any area not adhered to shell greater than 1/2 inch
in length and 1/8 inch in width
236
Multiple unadhered areas the total length of which
are 2 inches or more in length or any two
unadhered areas less than1/2 inch apart
146
Ends not butted together:
- open by more than 1/8 inch
147
- open by 1/16 inch up to 1/8 inch
237
Coated with helmet shell finish
238
Excessive glue on beading or helmet shell
239
Snap fasteners
Any fastener not functioning properly (i.e. fails to
(applicable to
snap closed, provide a secure closure or to open
snaps for
freely)
148
attaching inner
Clinched excessively tight, cutting webbing
149
helmet to shell)
Clinched loosely, permitting either component to
rotate freely
150
Incorrect style
151
Screws, posts,
Any screw not securely tightened
240
and washers on
Any screw too tight, causing cutting or crushing of
helmet shell
shell
152
Post on outside surface of shell in lieu of inside
241
Washer omitted
242
Any burr or sharp edge
153
Not finished -(when applicable)
243
Corroded
244
Attachment tabs
Any hole, cut, tear, or frayed edge
154
on helmet shell
Scalloped edges, not firmly and tightly woven
245
Ends not clipped as required
246
Ends not double folded
155
Fastener tape on
Any hole, cut, or tear
156
helmet shell
Any area not firmly adhered to shell
157
22
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business